I can't imagine it would be anything but aluminum, or perhaps thinner stainless but that is hard to drill (I imagine these were water/laser cut) holes into and probably more expensive than aluminum.
Welcome Guest!
In order to take advantage of all the great features that Waterloo Region Connected has to offer, including participating in the lively discussions below, you're going to have to register. The good news is that it'll take less than a minute and you can get started enjoying Waterloo Region's best online community right away.
Login or Create an Account
In order to take advantage of all the great features that Waterloo Region Connected has to offer, including participating in the lively discussions below, you're going to have to register. The good news is that it'll take less than a minute and you can get started enjoying Waterloo Region's best online community right away.
Login or Create an Account
Thread Rating:
Charlie West (Charles & Gaukel) | 31 fl | Complete
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 4 Guest(s)